Change the pump, most likely bad. Easy to do. Find washer reservoir and remove old pump, install new one.
lacing windshield fluid reseroir on 198 plymouth grand voyager
on the bottom of the washer tank good luck email me boy_dane @yahoo.com
Your 1986 Plymouth Voyager windshield wash your pump does have a fuse. The fuse can be found in the fuse box. The exact location of the fuse will be listed on the inside cover of the fuse box.
lift up the cap at the base of the arm, undo the nut, and disconnect the washer fluid hose..
You can't reset the fuse, it has to be replaced. Make sure to use the correct amp,it will be on the fuse. Example 10, 15, 20 etc.
Remove the wiring harness from the back of your Chevy Lumina windshield washer pump. Remove the windshield washer pump fluid hose. Remove the windshield washer pump retaining bolts. Reverse the process to install the new windshield washer pump.
Remove the wiring harness from your Volvo windshield washer pump. Remove the windshield washer pump fluid hose. Remove the windshield washer pump retaining bolts. Reverse the process to install your new windshield washer pump.
The windshield washer pump is located on the firewall in the engine compartment. Remove the windshield washer pump hose. Remove the wiring harness. Remove the windshield washer pump retaining screws. Reverse the process to install the new windshield washer pump.
First check under the hood, there might be a separate reservoir for it right by the windshield washer reservoir. It might also be at the back, lift the tailgate and there might be a little cap with a windshield wiper logo. Or the rear window washer might work off the front windshield reservoir. If it's shared at the front, then you'll have to keep the windshield washer fluid above the middle line on the windshield washer reservoir tank at least. Open the rear hatch. On the driver's side, there'll be a filler cap which is used to fill the rear window washer reservoir.
its inside the windshield washer fluid tank, you have to remove it to access the pump
On ours, it is behind an access panel in front of the RH tire.
Remove the wiring harness from the back of your 1993 Mercury Villager windshield washer motor pump. Remove the windshield washer pump hoses. Remove the windshield washer pump retaining bolts. Reverse the process to install your new windshield washer motor pump.