answersLogoWhite

0

The winding spring breaks or comes loose from its mount. Sometimes you can disassemble the cover over the belt retractor and see what the problem is, such as a small rock or dirt holding up the mechanism. They can also just get worn out and must be replaced. The seatbelt may also get twisted inside the retractor and muck it up. While you are in there, clean and freshen the grease points.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

Oldsmobile Intrique Rear right seat belt retractor?

there was a factory recall on them 2 years ago on the 98s. you should check with your dealer


How do you unlock the rear seat belts in your 1998 Oldsmobile Intrigue?

There has actually been a recall on the 98 intrigues because of the rear seat belts. They have a tendency to twist as they are pulled into the automatic retractor, causing the retractor to seize up. Had the same problem with mine. All I did was slowly pull the seatbelts a little at a time. When they would stop, I'd let it back in again to unlock the retractor, then try again. Took some patience and time, but eventually got them out.As for the recall, I think if you go into your local Oldsmobile dealership service center, they'll install guides that prevent the seat belts from twisting.See: http://www.automotix.net/autorepair/recalls/oldsmobile-intrigue/


How do you unlock seat belt retractor for a GMC Jimmy?

Pull the vinyl cover off of the seat belt, then roll the seat belt back on the roller.


How do you unlock a seat belt retractor in a Jeep Compass?

To unlock a seat belt retractor in a Jeep Compass, first ensure the seat belt is not twisted or tangled. Then, gently pull the seat belt out to its full length, which can sometimes unlock the retractor. If it remains locked, you may need to press the release button on the seat belt buckle and allow the belt to retract slightly before pulling it out again. If issues persist, consult the vehicle’s manual or a professional for assistance.


What is ELR in seat belt terminology?

ELR - Emergency Locking Retractor..Seat Belt Retract you when you face collision.


How do you remove the seat belt in a Ford Fiesta 1999?

To remove the seat belt in a 1999 Ford Fiesta, start by locating the seat belt buckle and the retractor. Use a screwdriver to remove any screws securing the plastic cover around the retractor and the buckle. Once the cover is off, unbolt the seat belt from its anchor points using a socket wrench. Finally, gently pull the seat belt out of the retractor and remove it completely from the vehicle.


How to replace seat belt 1997 Acura?

To replace the seat belt in a 1997 Acura, begin by removing the plastic trim covering the seat belt retractor and the mounting bolts. Use a socket wrench to unbolt the old seat belt from its anchor points, then detach it from the retractor. Install the new seat belt by reversing the removal process, ensuring it's securely fastened to both the retractor and the anchor points. Finally, replace the trim and test the seat belt for proper function before use.


How do you replace broken front seat belt on BMW 328i?

To replace a broken front seat belt on a BMW 328i, first, remove the lower trim panel and the bolt securing the seat belt retractor. Disconnect the seat belt from the buckle and retractor, then install the new seat belt by securing the retractor and buckle in their respective positions. Finally, reattach the trim panel, ensuring everything is properly aligned and secured before testing the seat belt for functionality. Always consult a repair manual for specific torque specifications and safety precautions.


Your seat belt on your 91 lumina won't pull back in?

bad retractor


How do you fix front seat belt on 1998 gmc suburban?

The only why to repair the seat belt (retractor) is to replace the assembly,no parts are available to rebuild this assembly.


How can you fix a front driver's side seat belt that will not retract on your 91 lumina?

replave retractor


How do you free up a Toyota seat belt that gets folded over and stuck in the retractor?

there is a recall for this