Flush the coolant, change the coolant resevoir and add new coolant, it doesn't hurt to change the hoses either
Try flushing the coolant system out
try giving soda... it helps :)
To unclog a Keurig coffee maker, first remove the water reservoir and clean it thoroughly. Then, use a paperclip or a needle to clear any clogs in the needle that punctures the K-cup. Run a cycle with just water to flush out any remaining debris.
To unclog your Keurig machine effectively, first remove the water reservoir and clean it thoroughly. Then, run a cycle with vinegar to descale the machine and remove any buildup. Finally, run a few cycles with clean water to rinse out any remaining vinegar.
There are no perfect rhymes for the word unclog.
If it is just water and not coolant, then more than likely the A/C drain line is plugged. Crawl under the car, passenger side, and find the drain line near the firewall and unclog it. If it is coolant then your heater core is leaking and needs replacing. Test the water and if it smells or taste sweet it is coolant.
I think the surgery that is done to unclog arteries is the bypass surgery.
You can not unclog it. You will have to replace it and that will take a mechanic about 2.5 hours.You can not unclog it. You will have to replace it and that will take a mechanic about 2.5 hours.
One could find instructions on how to unclog a toilet by going to the Art of Manliness website. The website has instruction on how a person can unclog a toilet.
You don't try to unclog it you just replace it with a new one.
you unclog it
unbolt the power steering line from the power steering pump. have another person inside the vehicle to start the engine. open the power steering reservoir. have the person inside turn the steering wheel back and fourth, left to right as you pour power steering fluid into the reservoir until it pours out clean from the unbolted line. make sure the loose line is seated into a pan or bucket to catch the fluid or you will have a mess. that should unclog the pump and the line. if the pump still doesn't work after you put the line back on, then you probably have a bad pump. replace the pump. hope this helps.