The best tactics to remove a stuck hub bearing is trying to knock it loose with a rubber mallet, the kind with lead shot in the head, you hit it enough on the sides and it should eventually loosen. if not a pry bar may help with some leverage, just try not to damage the hub assembly of course.
take it to get fix
how to remove key stuck in ignition switch in Chevy colbalt
Check the engine thermostat. Its probably stuck open.
You have to take the door apart
should i push it off a cliff
To remove the rear brake rotor from a Chevy Blazer, start by lifting the vehicle and securing it on jack stands. Remove the wheel and tire, then detach the brake caliper by unbolting it and hanging it securely to avoid stress on the brake line. Next, remove the caliper bracket if necessary, and then pull off the rotor. If the rotor is stuck, gently tap it with a hammer to loosen it, ensuring to avoid damaging other components.
WD 40, or a screwdriver and hammer, but the first one if you have the key
did u check if it was rusty or anything is stuck on the inside
I had this issue on my '87. I pried the plastic panel out of the channel enough to work the prybar into the latch and work it open.
check emc fuse and the fuse next to it
Car WILL NOT CUT OFF!! Running for at least 30 minutes. Goes in gear, but cannot turn key and take it out HELP
It's toast, replace it. Or have flying chunks of metal stuck in your ass.