0
What else can I help you with?
What does a 1985 Dodge pick up D250 have in it?
5.2L or 5.9L
How do you remove the ignition switch on a 2001 Dodge Ram 2500 pick up truck.?
To remove the ignition switch on a 2001 Dodge Ram 2500, start by disconnecting the battery to ensure safety. Next, remove the steering column covers by unscrewing the screws that hold them in place. Then, locate the ignition switch attached to the ignition lock cylinder, disconnect the wiring harness, and remove the mounting screws to take out the switch. Finally, reverse the steps to install the new switch, ensuring everything is securely connected.
Does your 85 Dodge truck have a camshaft sensor?
In 1985 they called a distributor pick up plate.In 1985 they called a distributor pick up plate.
How do you remove the ignition switch on a 1990 Chevy half ton pickup?
how do you remove the ignition switch on a 1990 chevy half ton pick-up?
How can you remove the gas sending unit from your 1985 Dodge pickup?
Disconnect and lower fuel tank from vehicle. Release lock ring from sender and pick up assembly. Install new.
How do you remove a fuel pump from 1995 dodge ram 2500 pick up?
Remove the fuel tank or remove the bed.
What is an i.o.d. for a dodge pick up?
Ignition off draw fuse/circuit It is used for dome lights, radio memory, etc.
How do you remove a bench seat in a Dodge Pick Up D-150?
should be 4 bolts on bottom of seat
How do you remove the ignition switch on a 1971 Chevy blazer without a key?
You would have to drill out the center of the lock or have a locksmith pick the lock.
You are looking for the location of the computer module on your 1989 Dodge Pick Up D100?
The computer module, or ignition control module, is locate on the left inner fender.
Where is the drain plug found on the transmission of 1997 dodge 1500 pick up?
There isn't one. You have to remove the pan to drain.
What is ignition timing on a 1999 dodge ram with a 318?
The distributor is not set with a timing light. It is zeroed to the crankshaft. Set the crank on its 0 mark, remove the distributor cap and check rotor alignment with the mark on the pick up plate. The dealer can fine tune this with his scan tool.
