0
The off and on switch indicator on a gear lever typically flashes to signal the activation or deactivation of a specific driving mode, such as sport or eco mode, or to indicate that the vehicle is in a temporary state, such as when the transmission is shifting or the system is recalibrating. This flashing light serves as a visual cue to the driver that the vehicle's settings are changing or that there may be an issue requiring attention. If the light continues to flash without a clear reason, it may be advisable to consult the vehicle’s manual or a professional mechanic.
What else can I help you with?
Gear shift lever button will not engage to move the gear shift lever out of park 2006 dodge stratus?
check the brake pedal switch
Why does your cbr 900 stall when you put it in gear?
The kick-stand switch or clutch lever switch have failed.
What is a Safety interlock switch?
Switch that prevents gear shift lever from moving from "Park" position until brake is applied
Where is the overdrive cancel switch on 2008 Toyota 4runner v8 limited located?
There is no "switch". To cancel overdrive move the gear lever from "D" to "4".
How do you turn off the overdrive in a 1998 Ford Mystique?
Push the button on your transmission gear selector lever that is below the thumb switch that you push to select a gear
Why will your 2001 Nissan Pathfiner not shift into gear?
The most likely cause is a failing shift lock switch in the center console. This switch prevents the gear shift lever from moving until the brake pedal is depressed.
240 Volvo will not shift out of park?
there is a little lever you have to switch to the left. It is inside the compartment where the on the bottom where the gear shifter knob comes out.
If An engine starts with the automatic transmission gear selector in any position?
That means the switch on the gearbox or lever is stuck for some reason.
Why wont riding mower go in gear either forward or reverse?
If you physically can not move the gear shift lever into gear, it could be a problem with the shifter linkage or the transmission. If you can select a gear by moving the the lever which is attached directly to the transmission, it is the linkage. If the lever moves into a gear but the mower doesn't move, it could be a broken belt or a bad transmission.
Shift lever will not lock into a gear?
700r4 gear shift lever want lock in place
What is the extra gear lever in Subaru Outback?
this is the lever that enables high and low gear for 4wd.
What does the manual lever position sensor do?
Is the device you are calling the manuall shift lever sensor really a neutral safety switch? It is a device to help prevent the vehicle from being startted in a drive gear.
