There is a microprocessor called the Insturment Panel Cluster Microprocessor. That controls several things, but one of the things it does is turn on the Daytime Running Light indicator and the High Beam Indicator. It could be bad. Are you sure that you have both High and Low beams? Check that first to make sure because the Turn/Hazard Headlight Switch could be bad causing you to have Hi Beams only. If you have Hi and Lo Beams, it is most likely the Microprocessor. Hope that helps.
its your service light
You have a headlight out.
How do you change bulb in abs dashboard\
When rays of light come together and are focused in a specific direction, they form a beam of light. This beam can travel in a straight line until it hits a surface where it can reflect, refract, or be absorbed.
If the abs light on a 4 wheel MX6 dashboard comes on, it is due to faulty abs sensor. It may also be due to a faulty rotor.
The only light that could come on would be the check engine light.
A converging beam of light is one that comes together at a point, typically caused by passing through a convex lens. In contrast, a diverging beam of light spreads apart as it travels, typically caused by passing through a concave lens.
no. however your indicator lights are located in your dashboard. dashboard light will light up when you turn your headlights on. Ex. the lights that are illuminated behind your miles per hour needle or behind your fuel gauge. Your indicator light are a lights that come on when your first turn the ignition. these lights indicate when your oil needs to be changed or your fuel is low or your washer fluid is low or the blue light that is illuminated when your headlights are on bright or high beam etc.....most newer model cars are equipped with the indicator lights. hope this is helpful.
There is an electircal switch that 'senses' when the emergency brake lever is applied and lights a warning light on the dashboard to keep you from driving in this condition. This switch may be faulty or out of adjustment, causing the warning light on the dashboard to turn on.
it looks like a transmission or the check engine light will come on
check your brake fluid and if that's ok your brake pads'Answer:If the light says "Brake Lamp", it means you have a tail light bulb that needs to be replaced.
A converging lens can cause a beam of light to focus or come together at a specific point called the focal point. This lens is thicker in the middle than at the edges, allowing it to refract light rays in a way that brings them to a single point.