answersLogoWhite

0

IF you have the black buttons on the steering wheel, on the RIGHT side, I believe the RESET button gives you the option to do the System Check. When the Oil life appears on the screen hit the RESET button again. A screen will then show up asking if you want to reset the oil life to NEW, if so select RESET again. The timing is very hard. It took me 3 tries my 1st time.

User Avatar

Wiki User

7y ago

What else can I help you with?

Related Questions

Where is the fuel reset button on a 2006 ford 500?

In the right front passenger footwell , in the right upper corner


How do you reset check engine light on ford 500?

You need a code reader that plugs into car's diagnostic port.


How do you change the brake light on a 2006 Ford 500?

Changing the brake light on a 2005 Ford 500 requires first exposing the light fixture. Locate the housing panel and uncover. Push and twist to remove the necessary light bulb socket for replacement.


How do you remove the center console from a 2006 Ford Escape?

how to remove console 2006 ford 500


What size oil filter do you need for 2006 ford 500?

According to the 2006 Ford 500 Owner Guide : ( Motorcraft FL-820-S )


What does the wrench light mean on a 2006 500?

I looked at the 2006 Ford 500 owners manual and it shows : Throttle control / transmission If the wrench light illuminates a powertrain fault or an AWD fault ( if equipped ) has been detected . Contact your authorized dealer as soon as possible


What does the light that looks like a camera mean on a Ford 500 2006?

The light for the anti-theft system is just to the left of the tachometer ( it's the picture of 1/2 of a car with a padlock )


Location of computer module in 2007 ford 500?

I have a 2006 Ford 500 and am having problems with my cruise control. I can set it but it only holds for maybe 5 minutes then shuts off and may or maynot reset. I have replaced my front rotors with aftermarket rotors does this have an effect? Can you help me resolve this issue. Thank you


Ford 500 all wheel drive problems?

how hard is it to change the oil pump in the transfer case in a 2006 ford 500 awd


What is the hp in a 2006 ford 500?

The horsepower for the 3.0 liter " Duratec " V6 engine in a 2006 Ford Five Hundred is rated at ( 203 )


How do you change a 2006 Ford 500 high mount center brake light?

To change the high mount center brake light on a 2006 Ford 500, first, open the trunk and locate the plastic cover or panel at the rear of the vehicle. Remove any screws or clips securing the cover, then gently pull it away to access the brake light assembly. Twist or unclip the old light bulb from the assembly, replace it with a new bulb, and reassemble the cover. Finally, test the new light to ensure it’s functioning properly.


Repalce tail light on 2006 Mercedes 500?

scesdfvsd