answersLogoWhite

0

Just connect it to one of the brake lights hot lead, and ground it to the truck.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Why doesnt right brake light on Dodge Intrepid 2001 work?

Bulb, wire, fuse, etc.


Why do you have power on every light wire except on your brake light on the passenger side in your 1993 dodge shadow?

Probably a broken or shorted wire, or perhaps a faulty ground. I'd check the ground wire first before tracing the hot wire. Both brake lights should be on the same circuit, so, if the problem isn't in your ground, it'll be between the plug and the point where the brake light wires split off from each other.


Why would one brake light and one reverse light not work on a 2002 dodge ram 1500?

most likely ground wire problem Bad bulbs?


Hooking up campershell brake lights on a dodge 1500 ram?

I have a 2011 Dodge Ram With Camper Shell. The 3rd brake light will wok but it never goes completely out. The 3rd light remains on very dim. Check voltage with brake pedal NOT pressed and you have around 9 or 10 Volts remaining on thus connection point. Any idea why and how to wire the 3rd brake light on this vehicle./


How do you bypass the brake light switch on a 1998 Cadillac Catera?

If your attempting to install a DVD player (in dash) in your car and need to bypass the brake light wire in order to be able to play it while driving its not too difficult. the brake light wire goes hot when the brake is applyied (to power the brake light itself) the DVD player uses this wire to know when the brake light is on or off based on if the wire is "hot" or not. simply splice the wire into a constant power source like the main power wire to your in dash unit.


Where is the trailer brake controller harness on a 2003 Dakota?

It isn't there, Dodge didn't wire the Dakota with one. You will have to wire the brake controller your self.


Can you wire neon lights to your brake lights?

Yes you can wire just about any light (neon, led, incandesant, etc... )to your brake light , granted it/s within the law. You plice into the brake wire, it's that simple.


Where is the positive brake light wire located?

Should be HOT at one side of the brake light switch


Can you tap a wire into the left brake light wire and run the new wire under the car and tap into the right brake light wire to make the right brake light work?

Yes I actually did it yesterday on my land rover I could not get my tail light to come on only my brake light. Use a decent wire like one side of a good speaker wire will do it's what I used. Tie it into the "hot" or positive wire of a working light into the positive of the non working. Make sure the lights you are tieing together do the same job i.e. Q brake light to a brake light. If that doesn't work check your ground. Also this only helps if the wiring is bad that is sending the light the signal if the fixture is bad you will have to replace it.


What color wire is the brake light wire in a 98 civic EX?

blue


Why do your brake lights work but the third brake light does not and not the ABS light is on?

New bulb needed or broken wire


What are the colored wires on the 4 way electric brake connector on a 2004 Dodge Ram Truck a 2004 Dodge Ram Truck?

the tn/rd wire is a power feed the dg wire feeds the trailer brakes. the wt/tn wire is the brake switch input. the bk wire is ground