a 327 bored 0.030 over is a 332CI so im assuming bore the block out to possibly 40 over or slightly higher.. or change too a bigger crank.
327 hp
its a 1967 engine most likely from a chevelle with 275 HP
The degree timing for a 327 cubic inch engine for a Chevrolet Corvette with is 4 degrees before top dead center. This engine is rated at 300 horsepower.
the 327 Chevy was buiit with anywhere from 210 hp with a 2 bbl carb to 375hp with fuel injection and everywhere in between.
All 2 barrel carb models and the base 250 hp engine are normally at 4 Degrees BTDC 300 hp engine sets at 8 degrees BTDC 340 hp & FI engine sets at 10 degrees BTDC Click the link and year on the left to check a particular year.
Has nothing to do with the HP, and depends entirely on engine make and model.
The '65 Vette varied in HP from 300, 350, 365, 375 and the big block at 425. What's amazing is that the 425 HP upgrade only cost $292 more.
370 hp
The 1963 Corvette has a top speed of 229 miles per hour. This model car has a 360-hp fuel-injected 327 V engine.
62 up 327 300 hp and higher had "camel hump" heads. these have 64 cc combustion chambers for 10.5 compression on a 327.
327, 235 hp. It was built on September 20, 1969 in Flint Michigan, and was designated to be in front of a powerglide in a full size car.
Replace it with a 6.5 hp engine...then it will be a bad bike. Other wise remove the governer but dont push it too hard