You fill the container on the drivers side and then remove the crossover plug that's in the middle of the black pipe, quarter inch square in the middle of it and fill till it comes to the top and burp the hose, (squeeze) to get as much air out as possible. You may have to do this a few times to get all the air out, then screw back in the plug and you're done. You fill the container on the drivers side and then remove the crossover plug that's in the middle of the black pipe, quarter inch square in the middle of it and fill till it comes to the top and burp the hose, (squeeze) to get as much air out as possible. You may have to do this a few times to get all the air out, then screw back in the plug and you're done.
No
go to markviii.org. they have a answer for almost anything with the lincoln mark viii
Where to find the horn relay fuse for a 93 Lincoln Mark VIII
no
Not unless you try to change the whole front end of the car.
you take off the coolan refill cap on the black pipe that is in front of the alternator using a 1/4" ratched or a small pipe wrentch , and fill the system with 50/50 mix until all the bubbles are out. DO NOT try to refill the system through the overflow resevior it will put an air bubble in your coolant system.
Yes it will if the 96 is a standard Mark Vlll, if the 96 is a LSC model it won't.
You didn't ask a question about a 95 Lincoln Mark Vlll. or yes, there is a 95 Lincoln Mark Vlll.
All models and years of the Mark Viii are v8's
To remove the coolant crossover tube on a 1993 Lincoln Mark VIII, first ensure the engine is cool and disconnect the negative battery cable. Drain the coolant and remove any components obstructing access, such as the intake manifold if necessary. Unscrew the bolts securing the crossover tube and carefully lift it out, making sure to replace any gaskets as needed during reinstallation to prevent leaks.
What is the question?
What's the question?