0
Remove passenger side fan that is attached to the radiator. Drain freon out of system. Remove electrial plug on compressor. Remove bolt that is located between the two hoses on an aluminum block attached to compressor. Remove the serpentine belt. Remove the 4 bolts that are located on the radiator side of the compressor. You now have it off but be careful not to damage the radiator when lifting it out.
What else can I help you with?
How do you replace a 1999 Ford Taurus fender?
how to remove a fender on 99 taurus
How do you replace the air ride compressor on a 1999 Cadillac DeVille Concours?
To replace the air ride compressor on a 1999 Cadillac DeVille Concours remove the air shocks located under each wheel and replace it.
Instructions to replace a 1999 Grand Prix GTP ac compressor?
To replace the AC compressor in a 1999 Grand Prix you must first remove the AC belt. Then disconnect the negative battery cable before removing the compressor bolts and connectors and removing compressor.
How do you replace freeze plug 1999 Ford Taurus?
How do you replace freeze plug 1999 Ford Taurus?
How do you replace ac compressor 1999 aurora?
Identify and remove freon. Remove the failed compressor and transfer the brackets, sensors, manifolds and switches to the replacement unit. Clean components that are not being replaced. Replace the dryer or accumulator. Install the new compressor.
How do you replace front parking light on 1999 Ford Taurus?
To replace front parking light on a 1999 Ford Taurus, lift the hood and remove the bolt holding the parking light housing cover. Twist the parking light off and replace with a new one.
How do you change battery cable on 1999 ford Taurus?
Remove the old follow same routing to replace with new
How do you replace the IMRC valve on a 1999 Ford Taurus?
This is the escort forum not the ford taurus.
How do you replace orifice tube on a 1999 Ford Taurus?
This is the escort page not the Taurus page.
How do you replace the clutch on the ac compressor on a 1999 mercury villager?
generally u dont replace clutch as it is more prudent to just get a used compressor from junk yard. you will need a pair of snap ring pliers. 1. remove nut on compressor shaft and remove clutch plate. 2. remove snap ring holding pulley on compressor. 3. use two screwdrivers on opposite sides of pulley to help slide off pulley.
Could you get an online diagram on how to put in an ac compressor for a 1998 Ford Taurus?
Try Autozone.com - they have a comprehensive on-line repair guide for the 1996-1999 Taurus/Sable.
How do you remove the engine from a 1999 Taurus?
you can remove the engine from the top by leaving transmission still in car
