Message Center Setup menu - Press 'Setup'
Press this control for the following displays:
• Language
• Units (English/Metric)
• System Check
.
.
.
Units (English/Metric)
1. Select this function from the SETUP menu for the current units to be displayed.
2. Press the RESET control to change from English to Metric.
Refer to the Owners Manual for the illustrated steps to the Message Center setup.
See "Related Questions" below.
with key on hold on to the minute and hour button at the same time count to three it should change if the clock is on 24hour with the car off do the same hope this help
Reset a fuel gauge? There is not reset for a fuel gauge.
UN plug battery for 3 min plu back.in
sorry , I don't believe there is one i called ford service center and was informed there is no reset button for ford freestar 2004. either i had to order a new airbag system or get to module computer a bypass to reset computer.
There is no reset for the fuel gauge. The sending unit in the fuel tank has probably failed.
Remove battery cable, reattach first step.
To reset the outside temperature gauge on a 2004 Mini Cooper, start by turning on the vehicle and allowing it to run for a few minutes. Then, find the reset button or switch on the instrument cluster, often located near the temperature display or on the dashboard. Press and hold the button until the display resets or shows a calibration mode. If the issue persists, it may be necessary to check for wiring or sensor problems.
The oil gauge does not have a reset. Is malfunctioning, the sending unit has probably failed.
To reset the door on a 2004 Ford Freestar, first, ensure that all doors are closed. Then, disconnect the vehicle's battery for about 10 minutes to reset the electronic systems. Reconnect the battery and check the door locks and windows to ensure they are functioning correctly. If issues persist, consult the owner's manual for specific troubleshooting related to door mechanisms.
To reset the check engine light on a 2005 Ford Freestar, you can disconnect the negative battery terminal for about 15 minutes. This will reset the vehicle's computer and clear the light. Alternatively, you can use an OBD-II scanner to read and clear any trouble codes. However, if the underlying issue isn't resolved, the light may come back on.
To reset the tire pressure warning message on a 2005 Ford Freestar, first ensure that all tire pressures are at the recommended levels. Then, turn the ignition to the "On" position without starting the engine. Press and hold the reset button located on the instrument panel until the tire pressure warning light blinks three times, then release it. Finally, turn the ignition off and back on to confirm the reset.
Simultaneously press the "E/M" and "MODE" buttons and hold for three seconds. This will reset the MPG average gauge.