Here are the instructions straight from G.M.
1. Turn ignition off
2. Ground ALDL Terminal K (this is the lower row, 3rd from the right).
3. Turn ignition on (don't start engine)
4. Wait for fault codes to begin flashing (approx 5 seconds). When the codes begin flashing, unground ALDL terminal K for 3 seconds + or - 1/2 second.
5. After ungrounding ALDL K as described in step 3 above, ground it again for 3 seconds + or - 1/2 second.
6. Unground ALDL K and wait 10 seconds. Before turning the ignition OFF, verify that code 12 is the only code being flased (this is the seatbelt/air bag light flashing). If not, codes have not been properly cleared. Repeat from step one if codes not cleared until the codes clear.
No,the driver-side airbag premiered on the 1990 Corvette as standard.Also the passenger-side airbag premiered on the 1994 Corvette as standard too.
No, not until the 1994 models.
== == No,the driver airbag arrived in 1990 as standard and the passenger airbag in 1994 as standard too.
1990 A new Corvette ZR-1 model debuts and a driver-side airbag becomes a standard feature.
how to reset oil timing on 1990 toyota
Inflatable restraint. Aka, your airbag
Just found out that it must be reset at the dealership with a diagnostic computer
== ==
I have a '90 prelude SR. It does not have an airbag.
the 1990 corvette had the LT-1 motor 300bhp and 340fpt that is the correct answer to this question!
Our 1990 Corvette convertible weighs 3301 pounds.
No