0
you dont. starting in the early 90's, many of fords engines were using DIS (distributorless ignition system). by the time the manditory switch to OBDII in '96 rolled around, all Ford engines had been switched over to DIS. this system uses one coil pack per 2 cylinders (so 3 on your V6), the coil packs are fired electronically by the engines computer. so in short, no distributor means no distributor cap or rotor.
What else can I help you with?
How do you replace a motor mount on 2002 Ford Ranger?
how do you change motor mount on 2002 ford ranger
Where is the distributor located on a 2002 Ford Ranger?
On a 2002 Ford Ranger : The engines ( 2.3 / 3.0 / 4.0 ) Have the Electronic Distributorless Ignition System ( EDIS ) So , there is no distributor The engines use a coil pack with either 4 towers for the 4 cylinder , or 6 towers for the V6 engines
What direction does the distributor turn on a 1989 Ford Ranger 2.8?
There is no 2.8 Liter in a 1989 Ford Ranger. The Ranger V6is a 2.9 Liter and the distributor rotates clockwise.
Install ignition 2002 Ford Ranger?
install ignition 2002 ford ranger directions
Does a 2000 Ford Ranger have a distributor?
No , the engines in a 2000 ford Ranger are E.D.I.S. ( Electronic Distributorless Ignition System )
How do you replace the front passenger side spindle on a 2002 ford ranger?
u use duct tape
Where is the EGR valve on a 2002 2.3L Ford Ranger Does the intake manifold have to be removed to replace it?
no its out side of the intake
How do you replace a u- joint on a Ford Ranger?
how to replace u-joints on 1995 ford ranger 2wd
How do you replace a water pump for a 2001 Ford Ranger?
how to replace water pump on 2001 ford ranger
How do you replace engine mountings on 2002 ford ranger 2.5 TD?
Well, you should ask the people who work at your local Ford dealer.
How do you replace a tfi on a 1987 ford ranger?
To replace the TFI (Thick Film Ignition) module on a 1987 Ford Ranger, first disconnect the negative battery terminal to ensure safety. Remove the distributor cap to access the TFI module, which is typically mounted on the side of the distributor. Disconnect the electrical connectors and unbolt the module, then replace it with the new TFI module, reattach the connectors, and reassemble the distributor cap. Finally, reconnect the negative battery terminal and start the vehicle to ensure proper operation.
What is the spark plug gap for a 2002 Ford Ranger 3.0L?
.044 inch for the 3.0 liter in a 2002 Ford Ranger
