like disk brakes
It is very easy to change the license plate light on an Oldsmobile Aurora. All you need to do is remove the license plate and look above where the plate was. There are bolts that are holding the light in. Unscrew the bolts and then replace the light.
you must take it to the dealership. there they can look up the frequency code that goes with your specifically.
Look for a blown fuse.
it is located in the glove compartment ,look around you'll find it .
Remove the plastic nuts on the gray cowl on the top of the engine. Notice the black plastic plentum, that's it.
Look under the dash or under the hood for a box labeled fuses. Check the owners manual.
Look at the top and left of the motor. It's easy to get to. The tension pulley is right below the alternator.
I'm thinking this model has a fuse box on the front drivers side... look for a panel to open all the way to the left towards the side
It should reset itself when the coolant is back to the appropriate level as long as the sensor is working properly. If you look in the overflow reservoir and can see coolant, the sensor or wiring might be the problem.
you have to go under the hood, and go into the fuse box on the left corner by headlight if you are facing car. you will have to look at manual and see what fuse to pull
There should be a map, either on top of the radiator, or glued to the underside of the hood. If not, go to a Library and look at some books.
[http://www.partsamerica.com/product_images/img/acd/a905c.jpg 1996 OLDSMOBILE CIERA SL L4 2.2 Liter FI] [http://www.partsamerica.com/product_images/img/acd/a925c.jpg 1996 OLDSMOBILE CIERA SL V6 3.1 Liter FI] Good Luck and Remember.Change Your Mind, Not Your Oil.Use the First In Synthetic Motor Oil's.See My Bio For more information.