There should be a three peice jack handle set that came with the vehicle. The square end of the the long peice about thirty inches is to be put into a hole next to the licence plate. then the lugwrech has a square notch in it that is used to turn the pole. Turn it counter clockwise t lower the tire and clockwise to raise the tire. after the tire is lowered to the ground ou must take the end of the cable and turn it ninety degrees to make it fit through the rim. jody goodyear tire and rubber company
Under the back of the van.
Remove the valve cover
"http://wiki.answers.com/Q/How_do_you_remove_Front_Rotors_on_a_1994_ford_ranger"
under the hood driver side
Under the body, on the driver-side, on the frame.
To remove the Powertrain Control Module (PCM) from a 1994 Ford Ranger V6, start by disconnecting the negative battery cable to prevent any electrical shorts. Locate the PCM, which is typically mounted near the passenger side under the dashboard. Unplug the wiring harness connectors by pressing the tabs and gently pulling them off. Finally, remove the mounting screws or bolts securing the PCM and carefully take it out of its bracket.
IN THE FUEL TANK. YOU HAVE TO REMOVE OR SLIDE THE CARGO BED BACK TO GET IT OUT.
under the inner fender of the left wheel drivers side
On a 1994 Ford Ranger, the fuse box is located under the dashboard on the driver's side. You can find it near the steering column, typically just to the left of the brake pedal. There may be a cover that you need to remove to access the fuses. Additionally, there is another fuse box located in the engine compartment, near the battery.
detach the bulbs and remove the clips behind the headlight assembly
carefully pop off the plastic cover on the handle and in the center there will be a screw
Try under the hood along the inner fender