I lost my retainer in the rear cupholder in the 1998 Ford winstar and it wasent good! I couldn't get it out . So my dad used a screwdriver to pry the cupholder out, then he used the screw driver to undo the bottom panel.After about 30 min.of trying to pry it out I stuck my hand in were the cupholder was and tried to grab it, it fell to the bottom of the panel and then we just was able to grab it out of the bottom. It was difficult but all we needed was a screwdriver and a small hand .
To remove a water pump from a 1998 Ford Windstar 3.0, you will need a tool called a tensioner. Disconnect the radiator and water hoses, then remove the water pump assembly.
Replace freeze plug in a 1998 ford windstar ?
A 1998 Ford Windstar would use refrigerant 134a
It is very simple. In the center of the holder when is pulled out as far as it will go, use a srewdriver blade to push down the tab. The cup holder will now pull out.
it is on the trans,right side you will have to remove cat.converters to access.
18mm
On a 1998 Ford Windstar : The 3.8 liter V6 engine ( and the 3.0 ) has a timing CHAIN
On a 1998 Ford Windstar : ( # 16 / 20 amp )
Reverse backwards and hit a boulder.. that thing will rip right off!
Not likely - the 1999 Windstar was a rather significant updating of design compared to 1995-1998 models.
On a 1998 Ford Windstar ( 3.0 and 3.8 ) firewall 1-----2-----3 4-----5-----6 front of vehicle > driver
On the underside of the engine.