Remove the inside door panel of your 1982 Chevy Corvette. Remove the window retaining clips. The window will lift out.
remove the window to get access to the nuts remove them then the mirrors look in the pillars an tighten them up.
The power window travel for a 77 Corvette is adjusted by bolts that are in slotted holes. Remove the door panel. Make small adjustments to each adjustment slot until the window travels properly.
First you will need to gain access to the parts holding the door handle in place. To do so, you'll need to remove the inside door panel, with the window up. From there, you'll be able to access the door handle.
== ==
== ==
Remove inside door handle and window crank handle, remove inside door panel, remove vent window and channel assembly, remove window.
== ==
First remove the Window Crank Handle. Then remove all of the screws you can find, 1 for the door release, 1 for the door grip, and 4 for the door panel. Pop loose all of the lower door area, and carefullyremove the door panel. Remove the plastic behid the door panel, SAVE IT!!. With the window all of the way down, remove the screws that hold the window in and remove the window. Revers to reinstall, being sure to locate the new window into the grooves for that.
To install a new window regulator on a MGRZ driver's door, remove the door panel and the wiring attached to the power window mechanism. Remove stereo speaker from the inside door and the window glass. Remove the old window regulator and replace with new.
You must remove door panel and replace window regulator.
the inner door panel has to come off and the whole window unbolts and it will come out.
First you need to remove the door panel.Then remove the door handle bracket.Peel back the moisture shield.Tape the window into place,then unbolt the window from the regulator.Remove the window regulator from the access hole in the door.