i know on a two door, the back seat has a plastic clip in the shape of a "C" that acts like a spacer to prevent the seat from moving just a tiny bit "1inch" to either side, when the seat moves to one side the other can come free. to remove the seat you will have to remove the clip from the left hand side bottom hinge, lay the seat down and slide it over, the reason for laying the seat down is the hinge has a slot in it much like a key and lock, it will only come out once its lined up. its really easy once you've done it.
Here's what my Haynes manual says. I'm not sure if it pertains to a split seat or not. It may be more Cavalier oriented than Sunfire oriented. Unlatch the rear seat back and tilt it forward. Unhook the outer side belt retractor from the rear seat back. Remove the spacer from right key pin. Slide the seat back to the right and disengage the left key pin from the left key slot. Slide the seat back to the left and disengage the right key slot from the right from the right key slot. (Haynes gibberish?) Remove the seat back. Press the seat cushion retainer to the rear with a screwdriver. Lift the seat cushion up and remove it. Installation is the reverse of removal. Haynes has no photos of the procedure. FriPilot
you pull them off
I have a base model and my back seat can be removed but it does not fold down. With the LS model the back seat folds down. Just depends on your model.
on my 03 carava there is a little button on the bottom where it slides into the seat
I have a 03 silverado and the jack is under the back seat on the passenger side
I have an 03 soft tail ... the fuse box is just rear of the battery ..... the battery and fuse box are under the seat .... you'll need to remove the seat to get to it ....
the horn relay on my '03 sunfire is under the dasboard taped to the wire bundle to the left side of the steering column.
remove the plastic trim covering the 4 mount points, 2 front / 2 rear the plastic trim is clipped on, so requires motivation to remove (be careful for the front middle, as mine snapped away from the clip & i had to use epoxy to glue it back together) remove the 4 T50 torx bolts remove the 3 wiring connectors at the base use the knob on the side to move the seatback forward as far as possible lift the seat out :)
On the tj model (97-03) open the back hatch of the jeep and on the bottom of the seat near the floor on the right side there is a latch that sticks out, pull up and the seat tumbles forward. On the tj model 04-06 there is a handle on the top part of the seat that releases the seat and allows it to tumble forward.
Um, which filter? Gotta be more specific.
That 30 amp fuse in in the fusebox under under the back seat near the battery.
to remove or change rear speakers on 97 to 03 grand prix..where carpet meets the bottom of rear bench on each side there is tabs, pul tabs and lift out rear seat ,there are two bolts holding in the bottom of the seat back one on each side above the seat pots.Remove the seat back by sliding up then out towards front of car(don't force hard! slide up first then pull outward!)the rear deck has bolts holding it down now in plain sight. remove the bolts/screws and slide the seat belts out of the deck and remove upward and out. You will now see the speakers are screwed in from the top. ps. unplug the 3" or 31/4" whatever they they are crap!use good 6by9 capped for 80!