answersLogoWhite

0

Follow the top hose on the radiator to the engine and it should connect to a rounded or bulbious 2-5 inch metal affair bolted to the top of the engine. Remove the bolts there and replace the thermostate inside. You migh want to flush out the engige cooling system at this time also.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

How do you replace a water pump on a 1996 Chevy Camaro z28?

How can do I replace a water pump on a 96 camaro z28


Can i replace the 4L60 trans in my 96 camaro Z28 with a 4L60e trans out of a 98 Z28?

The Camaro started using the 4L60-E in 1994, so that's what your 96 Camaro should be set up for already.


How do you replace the thermostat and were is it located on a 96 cadillac sedan deville?

In the motor.


How do you replace the thermostat on a 96 gmc jimmy?

remove the 2 bolts that hold the thermostat housing to the intake manifold which the upper radiator hose attaches to the housing then just pull the thermostat out and replace.


Why does your 96 Tahoe run cold?

Need to replace the thermostat with a 195 degree. That ought to do it.


Is the thermostat bad on 96 blazer?

If there is any doubt about it, just replace it, they are cheap enough.


Replace belt tensioner on a 96 camaro 3.8?

take the bolt out that holds it to the engine and it will come off.


You need to replace the thermostat on a '96 Camaro Z28 how do you do it?

1st u hav to tak the air intake hose off and the temostat housing should be on top of the waterpump. it should hav to screws holding it down, and the themostats should be under there


How do you change the oil pump on Chevy camaro 96 z28 5.7 engine?

how to replace oil pump on 1994 z28


Whats the exact firing for a 96 Chevy Camaro 3.8 RS?

The exact firing for a 96 Chevy Camaro 3.8 RS is 96 hp.


What could it be my 96 camaro lt1 stalls when moist and rains.?

probabaly a bad distributor. replace distributor and wires and should be fine.


How do you reset the check engine light on your 96 camaro?

pull the ECM/PCM fuse for a few seonds then replace it. that should reset it