0
What you need to do, loosen the axle nut jack up the car, take off both front wheels. Lock the steering wheel so it is straight. Remove the Rack and pinion from the wheel hub. Remove the lower ball joint on the hub. You will prolly need to use a pickle fork and a hammer. once that is done take out the axle nut. and tap on the axle slightly with the hammer it should be going towards the tranny. once you get that as far as possible move the hub out of your way making sure the axle is out of the hub. Then get underneath the tranny take your pickle fork and place it between the tranny and axle and tap on the handle with the hammer making sure it comes out slowly. Once it is out from the splines you can just pull it out the rest of the way. Repeat for the other side
What else can I help you with?
How do you replace the front axle and abs sensor on an 02 escape?
what do i have to do to replace the front drive axles on a 2004 ford ecscap???
Does a 1995 Ford Aspire have front wheel bearings?
YES
What is my 97 Ford Aspire front wheel or rear wheel?
front wheel drive
How do you replace serpentine belts in 1995 Ford Aspire?
There isn't one.
How do you replace a thermostat in a 1997 Ford Aspire and where is it located?
this site^ will show you a how
When to replace the timing belts of a Ford Aspire?
every 60,000 miles
Where is atf dispstick for automatic 95 Ford Aspire?
On a 1995 Ford Aspire : If you stand at the front of the vehicle and look in the engine compartment the automatic transaxle fluid dipstick is in the area to the LEFT of your battery ( according to a drawing I was looking at of the engine compartment of a 1996 Ford Aspire )
How do you replace a water pump on a 1995 Ford Aspire?
Its behind the timing belt cover
How many axles in 2004 Ford Escape?
The 2004 Ford Escape typically has two axles. It is a front-wheel-drive vehicle, but an all-wheel-drive option is available, which still utilizes two axles. Each axle supports either the front or rear wheels, depending on the drive configuration.
How do you replace a front fog light on a Ford Focus?
how to replace a front fog light on a ford focus
How do you replace a front wheel bearing on a 97 Ford Aspire?
To replace the front wheel bearing on a 1997 Ford Aspire, first, safely lift the vehicle and remove the front wheel. Next, detach the brake caliper and rotor to access the wheel hub. Use a bearing puller to remove the old bearing from the hub, then press in the new bearing, ensuring it’s seated properly. Reassemble the components in reverse order, making sure all bolts are tightened to the manufacturer’s specifications.
2002 ford ranger stuck in four wheel drive how can I get it unstuck?
Remove your front axles.
