under the back-seat.....
the battery is under the backseat
To replace the blend door in a 1998 Oldsmobile Aurora, first disconnect the battery and remove the dashboard trim to access the HVAC controls. Then, take out the heating and air conditioning unit to reach the blend door assembly. Remove the old blend door and install the new one, ensuring it is properly aligned. Reassemble the HVAC unit, reconnect the battery, and test the system to ensure it operates correctly.
How do you reset antitheft in oldmobie auroa
I got 13 years service from an original equipment battery in my 97.
The battery in 95-98 Aurora are located under the back seat cushion. To access you must lift the cushion by pushing in on the bottom rim from inside towards the trunk and lift up at the same time. To remove battery cables you need a 5/16 socket, and to remove the battery retainer use a 1/2 socket.
No, a seat from a 1996 Oldsmobile Aurora is unlikely to fit a 1998 Oldsmobile Cutlass. While both vehicles are from the same manufacturer, they have different interior designs and seat mounting configurations. It's best to check compatibility through specific part numbers or consult with a professional for accurate fitting information.
The coolant temperature sensor on a 1998 Oldsmobile Aurora is typically located near the thermostat housing, on the engine block. It's usually situated on the driver's side, towards the front of the engine. You may need to remove some components for better access, depending on the engine configuration. Always consult a repair manual for specific details and diagrams related to your vehicle.
it is in the tank drop the tank and then you will have access to it
The starter for a 1991 Oldsmobile 98 is located on the passenger side of the engine, near the transmission. It is mounted to the engine block and is accessible from underneath the vehicle. To replace or service the starter, it may be necessary to remove some components for better access. Always ensure the battery is disconnected before attempting any work on the starter.
To install a TCC (Torque Converter Clutch) in a 1994 Oldsmobile 98 Regency, first, disconnect the battery and drain the transmission fluid. Remove the transmission pan and filter, then access the valve body to replace the TCC solenoid. Reassemble the transmission components, ensuring all seals are in place, refill with fluid, and reconnect the battery. Finally, check for proper operation and any leaks.
where is the location of the horns on a 1990 Oldsmobile 98
The maxi-fuse relay center for a 1995 Oldsmobile 98 is typically located in the engine compartment, near the battery. It is housed in a black plastic box that contains several fuses and relays. To access it, you can remove the cover by unlatching the clips. For specific fuse diagrams and relay functions, refer to the vehicle's owner’s manual.