did you buy a brand new switch? or replace with another old one, i did the same thing on an old Chevy i had 2 switches, 1 would turn my headlights on but no dash, and the other would turn my dashlights on but no headlights, maybe just need to try another used switch. or by a new one.
1982
Fame - 1982 Bronco Bob Rides Again 5-3 was released on: USA: 26 October 1985
Check in the driver's side of the trunk area - should be a hinged panel for access
Are you asking if Malcolm Young owned an 82 Bronco? The answer is yes, a red and white one. 351 with a 3 speed auto.
To replace the headlight bulb: 1. Remove the headlight door. 2. Remove the four screws that hold the headlight bulb in place. 3. Pull the headlight bulb out and unplug the wire harness. Reverse the process to install the new headlight bulb.
i have a 82 bronco as well and i also had the same problem i checked the window motor and everthing was ok so i checked the PLUG in the dash where the switch is and found my problem it was the CONNECTOR it had come loose so i just pushed it back on and pow fixed it .....so try this out if you havent already found and fixed the problem good luck and thanks for your question
Either the bulbs are out, there is a grounding issue in the tail lights, or the headlight switch needs to be replaced. Do the side markers work? If no then it's probably the switch. If yes, then start checking for a bad ground wire on those tail lights.
On a 1982 GMC Vandura, the headlight fuse is typically located in the fuse box, which is found under the dashboard on the driver's side. You may need to remove the cover to access the fuses. Look for a fuse labeled specifically for the headlights, usually marked with a diagram or description. If you're having difficulty, consulting the vehicle's owner's manual can provide specific details regarding the fuse layout.
The headlight retract control relay on a 1982 Toyota Supra is typically located in the engine compartment, near the fuse box. It is often mounted on the driver's side fender or close to the headlight assembly. To access it, you may need to remove some covers or components for better visibility. Always consult the vehicle's service manual for specific details related to your model.
To replace the vent window on a 1982 Bronco, start by removing the door panel to access the window assembly. Then, carefully detach the vent window by removing the screws or bolts that secure it in place, and disconnect any weather stripping. Install the new vent window by reversing the removal process, ensuring a proper seal with new weather stripping if necessary. Finally, reattach the door panel and test the window for smooth operation.
for the tough ones use a socket that you can put a wrench on to crackem loose