To access the rear window washer water line on a 2000 GMC Jimmy, you'll need to remove the interior trim panel of the rear liftgate. Start by removing any screws or clips securing the panel, then gently pry it away to reveal the water line. The washer line is typically connected to the nozzle at the top of the liftgate; you can disconnect it for inspection or repair as needed. Always ensure the vehicle is off and that you handle the trim carefully to avoid damage.
If it's the back window washer that's not working, I had the same problem. Seemly the tube that carries the water to the rear window has become detached. How i realised this was that I had refilled the water container and still couldn't understand why the window washer arm was working but no water coming out onto the window. Then my back seat was wet. It was because the water was being pumped when I pressed the back window washer switch. Something made me turn around and you wouldn't believe it. The actual water was coming out of the top of the left back passenger seat belt near the top of the window. I still have to get this fixed. But it might be the answer you are looking for. My back seat has remained dry since realisation of this has prevented me from switching on the rear window washer.
yes
The window washer squirters that the water flows from are on the centre of the wiper arms by the wiper blades. The filler bottle is located behind the front bumper.
Check the rear window washer resivoir.
lift bonnet and locate a black plastic ( triangular shape ) grill under passenger side window wiper, when opened the top of washer bottle is there, i did remove the gauze filter from the neck of bottle as the washer fluid and water took ages to pass into it. under the drivers side window wiper is another plastic grill of the same where the car jack is kept. hope this helps. mick.
· windshield washer pump · water pump · window defroster · windows
Family Feud 1 - Window Cleaner 2 - Squeegee 3 - Water 4 - Towels
To add washer fluid to the rear window washer on a 2010 Dodge Caravan, open the hood and locate the washer fluid reservoir, which is typically near the back of the engine compartment. The reservoir cap is usually marked with a windshield/water symbol. Remove the cap and pour the washer fluid into the reservoir until it reaches the recommended level, then replace the cap securely.
Its located at the bottom of the water bottle. You can again access to it through the opening in the wheel arch on the drivers side.
Fluid leavel to low, Pinch or hole in the water line, or maybe it is reaching the window and the little hole where the water sprays out of is cloged, lastly, the water pump is not working or fuse is blown.
Yes, the washer has water in it.
There are two separate feeds from the washer tank. To access the washer tank you have to unscrew the trim under in the wheel well and pull it away. To do this you have to take the wheel off.