answersLogoWhite

0

First make sure car has warmed up. Idle or drive 15-30 min. Be carfull in engine bay as everything will be very warm to touch. Next, find trans dipstick. My 94 colt vista has it by firewall on drivers side. Check level and use a funnel to add fluid down the dipstick hole. Trust me, the long skinny trans fluid funnel keeps fluid from spilling all over. Recheck level. Test gears and\or testdrive car.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

Where is the transmission dip stick on a 1993 colt vista?

The transmission dipstick of an automatic 1993 Colt Vista is located on the passenger's side and is topped with a white handle. Manual Colt's do not have a dipstick. They instead have a fill hole directly on the transmission.


What type of motor oil to use for a 1993 Plymouth colt vista?

5w30 or 10w30


What is the towing capacity for a 1992 Plymouth colt vista?

Are you joking? The correct answer is 1 cooler of beer.


Where is the fuel pump on a 1995 Plymouth colt vista?

The fuel pump is in the top of the gas tank unfortunatly.


What is the button on your floor board of your 92 Plymouth colt vista for?

Try it with your lights on, its probably your Hi-lo dimmer.


How do you replace clutch 1991 Plymouth colt?

To replace the clutch on a 1991 Plymouth Colt, start by disconnecting the battery and removing the transmission from the vehicle. This involves draining the transmission fluid, detaching the drive axles, and unbolting the transmission mounts. Once the transmission is out, remove the old clutch assembly, including the pressure plate and flywheel, and install the new clutch components, ensuring proper alignment. Finally, reassemble the transmission and reconnect all components before testing the new clutch.


How do you check the transmission fluid in a Plymouth Colt?

In this job, you have to go under the car. I bought a book on 1989 Plymouth Colt E in 2005, but I don't think the sell them now. Anyway, 1.Get under the car were the gear box is. There you will find Screws. Un screw them and take that off. (they may be rusty) And there you go my friend!


You have 93 Plymouth colt vista transmission went out took pan off of trans an fluid was black and found a snap ring broke in the bottom of the pan but nothing else. trying to find free manual?

If the snap ring didn't go to the filter, it's probably not a good sign. If the ATF is black, it's an indication that the oil has burned and that the clutches have been slipping. In other words the transmission has failed.


Why would the transmission grind on a 88 dodge colt?

The transmission might grind on an '88 Dodge Colt because it is very low on transmission fluid. It might also grind because the gears are damaged or stripped.


Where do you check the dope in manuel transmission on an 1989 dodge colt?

To check the transmission fluid in a 1989 Dodge Colt with a manual transmission, locate the fill plug on the side of the transmission case. Remove the plug, and the fluid level should be just below the hole; if you can touch the fluid with your finger, it's at the correct level. If it’s low, you can add the appropriate manual transmission fluid through the fill hole. Always ensure the vehicle is on a level surface when checking the fluid.


How do you check the transmission fluid on a manual transmission for a 94 dodge colt?

To check the transmission fluid on a 1994 Dodge Colt with a manual transmission, first ensure the vehicle is on a level surface. Locate the fill plug on the transmission, usually found on the side of the transmission case. Remove the fill plug using the appropriate tool and check the fluid level; it should be just below the fill hole. If necessary, add the recommended type of transmission fluid until it reaches the correct level.


1993 dodge colt transmission not going into gear?

If your 1993 Dodge Colt is not going into gear, it could be due to several issues, such as low transmission fluid, a faulty clutch, or a problem with the transmission itself. Start by checking the transmission fluid level and condition; low or dirty fluid can cause shifting problems. If the fluid is fine, the problem may lie with the clutch components or internal transmission parts, requiring further diagnosis or professional assistance.