answersLogoWhite

0

What else can I help you with?

Related Questions

Where is the AC tension pulley for a 2000 Chevy Metro?

you dont adjust a tension pulley you adjust the position of the compressor to tighten the belt


How do you adjust serpentine belt on 2000 Chevy blazer?

You can't. it has an automatic self adjusting belt tensioner on it.


How do you change a serpentine belt on a 2000 Chevy metro 4-cylinder?

Disconnect battery a battery terminal Losen the Alternator bolt which is located on the up/down bracket. Once losen, you can adjust the tightness/slackness of the belt. Hope this helps, james


Can you change an alternator belt from under a 1998 Chevy Metro?

can you change the alternator belt in a 1998 Chevy metro from under the car.


How do you put an ac belt on a 2000 Chevy Metro 1.0 3 cyl?

To put an AC belt on a 2000 Chevy Metro 1.0 3-cylinder, first, ensure the engine is off and cool. Locate the tensioner pulley and use a wrench to relieve tension on the belt. Carefully remove the old belt and route the new belt according to the belt routing diagram, usually found on the engine bay. Once properly positioned, release the tensioner to secure the belt in place.


When should you change the timing belt on a 2000 Chevy?

A 2000 Chevy S10 does not have a timing belt.


Does a 2001 Chevy Metro have a timing chain or belt?

Chevy Metro 2001 (1.3 L) has a timing belt - hard driving conditions require its replacement at 60,000 miles, otherwise the timing belt replacement is scheduled for 100,000 miles.


Diagram of serpentine belt 2000 Chevy Prizm?

replacing serpentine belt on 2000 chevy prizm need help


Where to buy 3 cylinder timing belt cover for a Geo Metro?

chevy


When should you change the timing belt on a 2000 Chevy trail blazer?

The 2000 Chevy Trail Blazer doesn't have a timing belt.


How do you put an alternator belt on a Chevy Metro 2001?

To install an alternator belt on a 2001 Chevy Metro, first, ensure the engine is off and cool. Loosen the alternator mounting bolts to allow for adjustment, then route the new belt around the alternator pulley and the other pulleys according to the belt routing diagram, usually found on a sticker in the engine bay. Once the belt is in place, adjust the alternator to achieve the proper tension, and tighten the mounting bolts securely. Finally, check the belt alignment and tension before starting the engine.


My timing belt went out at at stop sign on my 2000 Chevy Metro. What are the probabilities that the valves are fine. I am looking for people who have had a like experience or know of someone who has?

VAlves are fine it will not bent valves