vertical adjusters are found above the outboard side of the lamp assembly. A special Torx wrench (E8) available at an auto parts store is required. The bubble leveler indicator inside the lens assembly should show when the lamp is properly set.
On my 2000 Windstar, the bubble leveler never moved so aiming process became a pure guess.
The headlight alignment procedures are detailed, and illustrated in the Owners Manual - See "Related Questions" below
The headlights of a Ford Windstar may have problems going on if they are burnt out or if there is a wiring problem. Blowing a headlight fuse will also lead to both lights not working.
If you respect others then you will go to an auto body shop and have them adjust them for you. I am sure you have had the experience of someone elses misadjusted headlights.
Have this done by a professional. You do not have the equipment to do this correctly.
how do you adjust head ligths up or down on a 2001 Isuzu rodeo
To adjust the headlights on a 2001 Chevy Tracker, park the vehicle on a level surface facing a wall about 10-25 feet away. Turn on the headlights and mark the center of the light beams on the wall with tape. Adjust the vertical and horizontal screws on the headlight assembly until the top of the beam is at or just below the tape mark and the beam is centered. Repeat for both headlights to ensure proper alignment.
I moved to France with my 2001 Kia Sedona and would like to know how to adjust the headlights for driving in France. Has anyone any ideas?
Not exactly sure on the Windstar, but recently had the same question for a Contour: try pulling on the lightswitch. Note: the fog lights on the Contour can only be turned on when the headlights are on.
it meams your mum has slept with your older brother and you sister is realy your niese
If your looking down at your headlights there will be a a screw on the bottom left of the headlight. It should be a 4mm. Counter clockwise will lower them and clockwise with raise them
To adjust the headlights on a 2001 Mazda Protege, first park the vehicle on a level surface about 25 feet from a wall. Turn on the headlights and mark the center of the beams on the wall with tape. Use a flathead screwdriver to adjust the vertical and horizontal screws located on the headlight assembly until the top of the beam is at or just below the marks. Finally, repeat the process for the other headlight to ensure both are aligned correctly.
The 2001 Windstar is rated at 200hp
A wire is broken, or pulled out of the multifunction switch plug.