Simple, trace two thin white wires from the column down towards the firewall, it should connect to a two pin harness with orange wires. Measure the ohms resistance of your key and then cut wires and splice in a resistor of the same value
cant by pass the alarm system...
Are you talking about the Pass-Key system? because the only real way to bypass it is to put in a new ignition.
123456 #1 one pass side
Pass lock security was not installed on 1991 GM cars. I believe it was 1997/98 it was first installed
It's called VATS bypass and you can get them on eBay cheap.
1,8,4,3,6,5,7,2. From front to back, Driv. side- 1,3,5,7 Pass. side- 2,4,6,8.
Yes, they do. They use the pass key chip system.
1-6-5-4-3-2 Its 135 on pass 246 on driverside 123456
Location of pass key controller module on 92 Camaro
The pass key module on a 1997 Camaro is located in the steering column, specifically near the ignition switch. To access it, you typically need to remove the lower steering column cover. This module is responsible for the vehicle's anti-theft system and communicates with the ignition system to allow the engine to start.
Down low on pass side. You need to get under the car to see it.
Using a VATS interrogator. A locksmith is a expert in this field.