Rear... 2 Phillips screws exposed when the tail gate is lowered.
Front... No tools required. Open the hood and remove the 2 plastic clips from behind the headlight assembly. Pull the headlight out, and you now have access to all the lamps. It can be tricky to get the headlight back in. It has two tabs on the bottom that MUST go into their holes. If you look carefully you can see that the tabs are in the holes. If you don't get them in there, the headlight will move unnecessarily, and worse, your beams will be misaligned. Once these bottom tabs are in the holes, then push the top tabs through their holes and re-install the clips. Be sure the clip is pushed as far down as possible on the square peg.
Usually this a faulty signal light switch. The Signal light switch disconects the brake light on the signaling side and makes it flash.
Open trunk. Remove gray thumb screw behind turn signal in trunk. Pull back carpet. Twist light socket clockwise, pull. Pull bulb out of socket.
ya check the fuse! lol
If the turn signal bulbs light but will not flash, the flasher relay is defective, replace it.
how do you change a fan switch on a 1997 Chevy cavalira
Good luck with that.
How do you change the water pump on a 1997 chevy malibu?
On some, you can get to the back of the light assy and take the bulbs out. If not, the assy has to come off
how do you change a ac fan switch on a 1997 Chevy cavalier
Where is the thermostat on a 1997 chevy suburban and how do you change it?
assuming you mean the light bulbs, see the answer to "how do you change turn signal lamps both front and rear on a 96 mercury grand marquis" right here in WikiAnswers.
How do I change the clock setting on a 1997 Chevy Lumina with a CD stereo system?