0
This is an easy one. Remove the two screws that hold the taillight to the body. They are located just inside the tailgate. The taillight has two tabs the fit into slots opposite the screws, so you'll need to swing the assembly as if you're opening it like a door. The brake light is the top bulb on the back of the taillight. This is assuming that you weren't referring to the "3rd eye" brake light, which I haven't done.
What else can I help you with?
How do you change the center third brake light on a 2003 E320?
Begin by removing the wiring harness from your third brake light. Remove the third brake light retaining screws. Reverse the process to install your new third brake light.
How do you change brake light bulb on 2003 Subaru Forester?
Not to be unkind - but READ THE MANUAL.
How do you change front brake pads on 2003 neon?
how to change front brake pads on a 2003 neon
How do you change dome light fuse jeep liberty 2003?
The dome light fuse on a 2003 Jeep Liberty can be changed by first locating the fuse panel near the hood release. The dome light fuse can then be pulled from its socket and a new fuse put in place.
How do you change the brake light on a 1991 through 2003 Ford focus?
I have the ZX5 2003 and when I did it I had to open up the trunk and go through the inside.
How do you change the cabin air filter on 2003 Liberty Jeep?
A 2003 Liberty does not have a cabin filter.
What type of brake fluid is used in a 2003 Jeep Liberty?
Dot 3
How many sensors does the brake pads have for a 2003 Nissan altima?
brake light and battery light is on
What is check engine light code p1491 on 2003 Jeep liberty?
what is this code p1491 on 2003 jeep liberty
Where is the brake light switch for 2003 HD Chevy truck?
Where is the brake light switch for 2003 hd Chevy truck As far as I know, all brake switches are on the top of the brake pedal arm.
How do you change brake light on peugeot 106 2003?
To change the brake light on a 2003 Peugeot 106, first, open the rear hatch and locate the tail light assembly. Remove the screws or clips securing the assembly, then gently pull it away from the vehicle. Disconnect the bulb holder from the assembly, replace the old brake light bulb with a new one, and reassemble everything by reversing the steps. Ensure the new bulb is securely fitted and test the brake lights before closing the hatch.
How do you replace a brake light on the driver side in a 2003 Jeep Liberty?
There are 2 small screws reachable through the rear-gate hinge. These need to be removed then pull entire light housing striaght back.
