answersLogoWhite

0

Check your owners manual. If you don't have one copy & paste this link. http://www.genuineservice.com/genuineservice/en/gloveboxresults

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

Can you drive your ford expediton if the battery light is on?

yes you can but only until the battery goes flat either the battery or the alternator is bad drive it to a shop or you will end up broke down on the side of the road


How you change a flat tire on a Ford Taurus wagon?

You can change a flat tire on a Ford Taurus Wagon by first removing the lug nuts, pulling it off, and replacing with the spare tire.


What is the flat rate time to change thermostat in 2000 Montana?

3 to 4 hours


How do you take wheel off 1994 Ford Taurus to change a flat?

take off the lug nuts..........


Tools needed to change fuel filter on 1997 Ford Crown Victoria?

A flat head screwdriver.


How do you change a dim gear indicator light on a 2000 Ford Contour?

pop off the cover using a small flat head screwdriver, slide it up the shifter an inch or two. you should be able to feel where the bulb slides in. pull bulb out and replace.


What kind of tool needed to change back blinker bulb in 94 Ford Taurus station wagon?

Ratchet and flat screwdriver


How do you change a flat on a BMW 740iL?

How to change flat on a 740il


What domestic SUVs can be flat towed?

can a ford expedition be flat towed?


How do you change a ignition on a 1995 ford f150 with no keys?

Well you could ram a flat head into the ignition and turn it to the on position then take steps


Can you flat tow a Ford Focus?

No!


How do you change the cv joint on a 2000 ford winstar left side?

To change the CV joint on the left side of a 2000 Ford Windstar, begin by safely lifting the vehicle and removing the front wheel. Disconnect the axle nut and any components obstructing the axle, such as the brake caliper and rotor. Slide the axle out of the hub and remove the inner CV joint from the transmission, which may require prying with a flat tool. Install the new CV joint by reversing the removal process, ensuring everything is properly aligned and torqued to specifications.