0
its a lenghthy job , first remove tire and unbolt and move the brake caliper out of your way, then unbolt the CV shaft nut and remove washer. Now for the fun part remove rotor so you can see wheel bearing case. Proceed to heat the bearing casing and bolt with a torch till it is red hot, then break the n
bolts loose with your 11mm socket, the CV shaft will need to be pushed back far enough to get the socket on straight and take care not to strip the heads of the bolt. The wheel bearing comes off as a unit with the hub. replace with new one and put everything back together in reverse order.
What else can I help you with?
Where is the battery for a Plymouth breeze 1998?
The battery is inside the left front fender, in front of the tire on a 1998 Plymouth Breeze.
How do you change the battery of a 2000 Plymouth breeze?
You take off the left front wheel and housing. It isn't under the hood.
How do ycu change the battery on a 1997 Plymouth Breeze?
Remove the left front wheel and inside fender skirt. The rest becomes obvious.
What size is the front hub nut on a 1996 Plymouth breeze?
32 m
Where is the starter for a 96 Plymouth breeze?
Between the front of the engine on the bottom and the radiator
Where is the starter located on a 1999 Plymouth breeze?
On the front of the engine, near the rad fans.
Where is the battery on my 99 Plymouth breeze?
It is under the inner fender liner in front of the driver side front tire.
Where is the oil pump located on a 2000 Plymouth breeze?
Since the Plymouth Breeze came only with a four cylinder, the oil pump would be driven directly off the crankshaft at the front of the motor.
Where is the air filter on a 1999 Plymouth breeze?
It is under the hood, in the box at the front driver side.
Where is the water pump on a 2002 Plymouth breeze?
It is inside the front of the engine, driven by the timing belt.
Towing a Plymouth breeze without damaging transmission?
The front tires need to be off the ground.
Where is the shifting solenoid on a 1998 Plymouth breeze?
Front of the trans, below where the cooler lines attach.
