Go to this site: http://www.bfranker.badz28.com/headlightfix/index.htm I just order his fix and it worked great except use some good epoxy....the stuff he sent wasn't the best....$45 to fix the light.
a Pontiac 301
On a 2002 Pontiac Trans Am, the headlights' up and down movement is controlled by a combination of the headlight switch and the headlight motor assembly. When the headlight switch is activated, it sends a signal to the headlight motors, which then raise or lower the headlights accordingly. Additionally, there may be a relay involved in this process, ensuring proper electrical flow to the motors. If the headlights are not functioning properly, it could be due to a faulty switch, motor, or wiring issue.
I have a 1988 corvette I need to change the headlight motor but cant get the motor free from the body This answer is a question.
try all American classics in Vancouver, Washington they had all the parts i needed for my firebird so im sure they will have that there. here is the website http://www.allamericanclassics.com/
The starter on a 2001 Pontiac Trans Am is located on the driver's side of the motor. It is down low towards the back of the motor.
3.4l or 3400 v6
Buy a motor manual with one in it.
There's a plastic gear inside the headlight motor that becomes stripped, which causes the grinding noise. You can either buy an aftermarket metal one (an internet search will turn up some good sites) or use pieces from a kit for power windows. I brought the idea up to my mechanic and he had it done in less than a day for about $110. You can buy a refurbished headlight motor $180. I tried replacing the gears in my headlight motor, but after a while, the gear ended up stripped again. I recommended replacing the motor. Go to YouTube and type in 4th gen firebird trans am headlight fix. Easy 10 minute adjustment at no cost. Mine ground really bad, thought I had to replace the gears.
Under dash on passenger side
your motor needs to be replaced,or it could just be the module on the motor.
YES,BUT YOU WILL HAVE TO CHECK MOTOR MOUNT LOCATIONS AND CHANGE AS NESESSARY. ALSO YOU WILL HAVE CHANGE DRIVESHAFTS ALONG WITH ALL NESSESARY LINKAGE AND OF COURSE THE CLUTCH PEDAL.
stock 285 ram air stock 305 bhp