answersLogoWhite

0

Remove the two screw from inside tailgate area, then carefully unhinge lamp. Bulbs will just unscrew within there plastic holders. Good luck.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

How do you change the tail brake light in a 92 Chevy Suburban?

Unscrew the bulb by turning it coumterclockwise and it will come out of the assembly.


How do you replace a 1999 suburban tail light bulb?

The tail light bulb on a 1999 Chevy Suburban is replaced by removing the retaining screws, pulling the bulb assembly away from the vehicle, and unscrewing the bulb. A new bulb can then be installed and the assembly screwed back in place.


Why do your left rear tail light and blinker not work on your 1997 suburban?

Bulb is blown. Replace bulb.


How do you change a tail light on a 2006 sequoia?

how to change tail light bulb on Toyota sequoia


How do you change the brake light bulb on a 2002 Chevy suburban?

If you put the tail gate down and look at the inside of the bed whare the tail light is mounted you will see 2 small screews. Remove the screews and take the light out and you will see the bulbs in the back of the light.


How do you change brake light bulb on a citroen C4 sx?

how do you change a brake light bulb from a citroen c4 tail light unit. thanks


Is it necessary to remove the tail light assembly to change the tail light bulb on a Mazda MPV?

Yes unfortunatly


Change hhr tail light bulb?

What is the part number for the 2008 HHR tail light bulbs and backup light bulbs?


How do you change a tail light bulb on a 1998 grand prix?

To change a tail light bulb on a 1998 grand prix you have to first take out the carpet from the trunk. Next, you will be able to get to the bulb just remove the case holding covering the bulb then twist, remove and switch the bulb.


I have a ford contour and the tail light and brake light is the same bulb but the brake light WORKS but not the tail light what can be the problem. I CHANGE THE BULB TWICE?

When the tail light and break light are on the same bulb said bulb has 2 elements, one for the break and the other for the tail light, one element is burned out. Replace the bulb. If you've replaced the bulb, it might be the wiring. The holder for the bulb sometimes is at fault. They are $40.00 at the dealer, but at a pick a part or salvage yard they are $2.00.


How do you change the rear blinker bulb in 2006 dodge caravan?

remove tail light, remove burnt bulb, replace burnt bulb, test if it works, then put tail light back on....


Chevy Avalanche high mounted tail light out?

change the bulb

Trending Questions
What order are the spark plug wires on Oldsmobile 307 distributor cap? How many dodge cudas were made in 1970? What size gas tank on 2008 dodge durango? What type of power steering fluid should you use for a 1994 Chevy astro van? How much does it cost to repair the crankshaft in a 1997 Nissan Altima? What are the model numbers for the 3 speed and 4 speed manual transmissions for the 1974 Roadrunner? Where does the power steering fluid go in 2003 Chevy impala? 2003 Crown Victoria windshield wipers will not turn off how do you determine what to replace the wiper motor or wiper relay switch? Which cylinder is the number five cylinder in a 2007 ford freestyle? Where is the iat sensor on a 2006-2007 Honda civic ex and which of the 5 wires are the iat and not the maf need to know for installing a power chip? What is the wheel stud size on a 1970 Chevelle? How do you change the oil filter in a 05 Sunfire? Where is the water pump on a 2003 envoy? When do I use the od button on 2003 Ford Ranger? What is the lug pattern on a 2001 Chevy Suburban? How do you remove the crank pulley on a 1995 Geo Metro It's a very very tight fit for any tool to get in there Is the bolt or nut righthand threads or left Do you need a puller also There's no room? Will removing the muffler on a diesel engine cause problems? How do you replace an ignition coil on a 2001 Blazer? Where is the fuel pressure regulator on a 1996 dodge avenger? 1998 Chevy Astro Van water sound in glove box are and water leakwhat would cause this?