answersLogoWhite

0

slim near the thermostat housing with two wires on it

User Avatar

Anonymous

4y ago

What else can I help you with?

Related Questions

Where is the coolant temperature sensor located in a 1995 Chevy astro van?

The 1995 Chevrolet Astro and coolant temperature sensor can be found on the front of the engine. The coolant temperature sensor will be a few inches above the thermostat housing.


Where is the iat sensor on a 1995 Chevy suburban with a 454 engine?

Iat / Idle air temperature sensor was not used on that year.


Where is the temperature Sensor on a 1995 Chevy S10 Blazer?

The temp sensor for the ECM (engine control module) is next to the thermostat housing.


Where is the intake air temperature sensor located on a 1995 Chevy silverado 3500 with a 454?

That sensor was not used on that year. IT DON'T HAVE 1


Where is the Intake Air Temperature sensor located on a 1995 Chevy Tahoe?

There is no Intake Air Temperature sensor on a 1995 only 96 and newer. If you are asking because you are putting some sort of performance module on it then you need to hook that up to the Coolant temperature sensor which is located next to the thermostat and it is a two wire sensor.


What causes temperature gauge to go out on a 1995 Chevy Camaro z28?

Most likely a bad sensor/relay


Where is the fan motor temperature sensor on a 1995 Chevy lumina 3.8 liter?

on the right of your PC valve Where is the PC valve?


Where is the transmission oil temperature sensor on a 1995 Ford Escort?

There is no transmission oil temperature sensor on a 1995 Ford Escort.


Where is the IAT sensor located on 1995 Chevy G20?

A 95 did not have IAT sensor


Does a 1995 Chevy Camaro Z28 have a crank sensor?

No it does not


Where is the temp sensor located on a 1995 Nissan Altima?

The 1995 Nissan: temperature sensor is located on the front of the engine. The coolant temperature sensor will be near the thermostat housing.


How do you change an O 2 sensor for a 1995 Chevy Beretta?

It requires a special socket with a slot in the side so as not to harm the wiring.