answersLogoWhite

0

Disconnect it from the Box under the battery, clip the zip-tie and lay it loose. Disconnect it from the Pedal. Back under the hood, remove the plug from the firewall and the cable will come right out. Very EASY, far more easy that finding the replacement part.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

How do you change the heater core in a 2004 dodge ram 1500?

the hole dash has to come out . just change mine in a 02 dodge ram 1500.


What would cause bad gas mileage on 1999 dodge ram 1500?

Putting your foot down too hard on the accelerator.


Where is speedometer for cable for 1994 dodge 1500 truck?

The speedometer does not have a cable on a 1994. It is run by a sesnor on the rear of the trans/t-case.


How to change the speedometer cable on a 1990 Honda Gold Wing 1500?

how do you change the speedo cable on a 99 goldwing 1500, and how do you lube the front end/ I need instructions, not parts


Dodge ram 2001 1500 throttle stuck even in neutral?

replace the throttle cable.


Will the dash wiring harness out of a 1993 dodge ram 1500 inter change with a dash wiring harness out of a 1997 dodge ram 1500?

No.


How do you change blower fan resistor on 1997 dodge 1500?

To change the blower fan resistor on a 1997 Dodge 1500, first disconnect the negative battery cable for safety. Then, locate the resistor, which is typically found behind the passenger side dashboard, near the blower motor. Remove the screws or bolts holding it in place, disconnect the wiring harness, and replace it with the new resistor. Finally, reassemble everything and reconnect the battery cable.


What size wrenches are needed to change a starter on a 2000 Dodge pickup 1500 4x4?

The bolts on the starter take a 5/8 inch wrench. The battery cable is a 13mm wrench.


Can you change a 95 dodge ram 1500 obd1 to an obd2?

No. You can not change to OBD 2.


How do you change a speedometer cable on a 99 Chevy 1500 express van?

It doesn't have a speedometer cable. It is electronic.


What is a code P0123 for a 1998 dodge ram 1500?

Throttle Position Sensor(TPS)/Accelerator Pedal Position Sensor(APPS) signal voltage high.


Reset alarm on 2001 dodge ram 1500?

To reset an alarm on a 2001 Dodge Ram 1500, disconnect the battery cable for 10 minutes. Users can also disable the alarm by inserting the key into the door.