answersLogoWhite

0

Disconnect your negative battery cable. Pull out the coil to distributer cap wire. unplug the wires going into the coil, remove the bolts holding the coil mounting bracket and slide coil out.

User Avatar

Wiki User

19y ago

What else can I help you with?

Related Questions

What is the ignition timing for a Mazda 323 1991 DOHC B5 engine?

ignition problem


What is the ignition timing for 1991 Toyota pickup?

wich engine do you have?


Where is the ignition module on a 1991 Oldsmobile regency?

The Ignition Control Module is on the top left hand side of the engine under the Ignition Coils.


Where is the dura spark ignition module located on a 1991 Ford probe?

The 1991 Ford Probe spark ignition module can be found on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.


1991 Honda Accord engine cuts out while driving?

Ignition switch


When did ECM take over from manually adjusting the distributor to change ignition timing.?

Right from the 1991 Explorer , the 4.0 L OHV engine was EDIS ( electronic distributorless ignition system ) using a coil pack instead of a distributor


A engine diagram for a 1991 2.2 Honda Accord for the coolant hoses?

A Ignition coil diagram for 1991 2.2 Honda accord


How do you change a ignition switch on a 1991 cougar?

Ok so you have to go where the ignition switch is at on the 1991 cougar. Next, You have to take the old one out. Last, you have to put the new one in.


How do you change the ignition key on a 1991 Toyota Previa?

Turn the key to acc. and push the plunger in located on the Ignition lock housing


How do you change the ignition switch on a 1991 Pontiac grand am tilt steering automatic trans?

I don't know how to change the ignition switch but I have some advice. Don't screw with the ignition switch, buy the whole steering column. It will be cheaper and easier to change.


How do you change the key cylinder of the ignition switch in a 1991 acura legend?

Remove the retaining ring at the top of your 1991 Acura Legend ignition switch. The ignition switch cylinder will slide out. Remove the wiring harness from the end of the ignition cylinder. Reverse the process to install your new ignition switch cylinder.


Where is the coil ignition located for 1991 beretta 3.1?

front of engine block right next to the starter.