To change the brake light bulb in a 2003 Alero, first, open the trunk and locate the tail light assembly. Remove the screws or clips securing the tail light, then gently pull the assembly out. Twist the bulb socket counterclockwise to remove it, replace the old bulb with a new one, and reassemble by reversing the steps. Ensure the new bulb is securely in place before closing the tail light assembly.
Check the brake pedal switch. Check the bulbs. Check the grounds.
The brake light switch is located under the dash drivers side under a sound cover held in place by 2 screws, not that hard to remove.
In the Haynes workshop manual.
Begin by removing the wiring harness from your third brake light. Remove the third brake light retaining screws. Reverse the process to install your new third brake light.
Not to be unkind - but READ THE MANUAL.
To change the antifreeze on a 2003 Alero once the car cools remove that radiator pressure cap. Pour in a gallon of pre mixed coolant.
On a 2003 Oldsmobile Alero, the fog light fuse is located inside the dashboard fuse box on the right. The fog light fuse is a ten amp fuse.
how to change front brake pads on a 2003 neon
Should be labeled or just look for the bad one
I have the ZX5 2003 and when I did it I had to open up the trunk and go through the inside.
brake fluid, the clutch works the same way your brakes do.
Try about 25 lb. ft. for the caliper bracket.