To change the driver's side axle on a 1993 Geo Storm, first, lift the front of the vehicle and secure it on jack stands. Remove the wheel, then disconnect the brake caliper and rotor to access the axle. Next, remove the axle nut from the hub, then detach the axle from the transmission by pulling it out of the transmission housing. Finally, insert the new axle, reassemble the components in reverse order, and ensure everything is securely fastened before lowering the vehicle.
How do u remove front axle u joints
how do you take off drivers side axle- 93 escort wagon? Kevin
That would depend on what the axle code is ( the axle code can be found on an information sticker on the end of the drivers door or perhaps the latching pillar )
To change the CV boot on a Geo Storm, first, safely lift the vehicle and remove the wheel to access the CV axle. Next, detach the axle from the hub and remove the old CV boot, ensuring to clean off any grease. Slide the new boot onto the axle, apply grease to the joint, and secure the boot with clamps. Finally, reassemble the axle to the hub, reinstall the wheel, and lower the vehicle.
Change you top strut nut.
it's located on the drivers side just forward of the gas tank above the rear axle.
1984-1993 Jeep Cherokee XJ Rear Axle 1987-1993 Jeep Wrangler YJ Rear Axle 1986-1992 Jeep Comanche Rear Axle
To replace the axle on a 1993 Honda Civic the axle nut has to come off. The hub assembly also will need to be pulled back so the axle can be pulled from the transmission.
filter is located under car behind rear seat drivers side, by the axle
There is one main thing you will need to know when removing CV axle from the transmission on a 1995 Mazda 626 on the drivers side. You will need to know that the circlip is what holds the axle. If you unclip that the axle will fall right out of the transmission.
if you have to ask how to do this job, then it is beyond your ability. that bearing is pressed on the axle........
yes...you may need some special body contorsion.