answersLogoWhite

0

Take the 2 screws out on the sides of the housing,then lift it up,disconnect the wiring from underneath...then remove the 2 srews from under the top ...separate the parts to access and change the bulb....reinstall in reverse order....

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

How do you change the light bulb in the ashtray of a 1992 Cadillac Brougham?

take to cadillac dealer


Is there a trunk light on a 1987 Cadillac Brougham?

yes


Why my dash lights don't work in my Cadillac Brougham 1990 even if no fuse are burned?

check to see if the ligt intensity is turned down on the headlight switch. Also check brake light fuse. Good luck


When did cadillac introduce the third brake light?

1985


Where can you find the brake light fuse of a 1990 Cadillac Brougham?

In the fuse block, under the lefthand end of instrument panel, beneath a plastic panel fastened with two screws. This fuse is shared by the hazard system - check first if the hazard lights work, if they do the fuse is ok and the fault elsewhere (brake light switch possibly).


What are the panels called between the tail light and quarter panel on a 1987 Cadillac Brougham?

They are commonly referred to as filler panels.


Change center brake light on Hyundai?

what do you have to do to change the center brake light


Why might the brake lights not work on a 1998 Cadillac Catera?

Bad brake light switch


Where is the headlight circuit breaker located on a 1987 Cadillac Fleetwod brougham?

at least on a 79 fleetwood it is located in the light switch itself


How do you change the tail light on a 1987 Cadillac Brougham?

There are several torx head screws around the rim of the lens. If it just one of the bulbs that needs changed and the screw heads are stripped, you can get to the bulbs by reaching under the tail fin and into the back of the light.


How do you change the center brake light on a 2006 Cadillac CTS?

To change the center brake light on a 2006 Cadillac CTS, first, open the trunk and locate the plastic cover behind the rear seat. Remove the cover by unscrewing any screws or clips, then disconnect the light assembly from the wiring harness. Replace the old bulb with a new one, ensuring it's securely in place, and reassemble the cover and any fasteners. Finally, test the brake light to ensure it’s functioning properly.


How do you change the brake light on a 2007 Cadillac STS?

To change the brake light on a 2007 Cadillac STS, first, open the trunk and remove the access cover located near the tail light assembly. Disconnect the electrical connector, then twist the socket counterclockwise to remove it from the assembly. Replace the old bulb with a new one, reinsert the socket, and reconnect the electrical connector before securing the access cover back in place. Finally, test the brake light to ensure it’s working correctly.