0
To change the ignition switch on a 1997 Geo Tracker, first disconnect the negative battery cable to ensure safety. Remove the steering column covers by taking out the screws and bolts that secure them. Then, locate the ignition switch, disconnect the wiring harness, and unbolt the switch from its mounting. Install the new ignition switch in reverse order, reconnect the wiring, and reassemble the steering column covers before reconnecting the battery.
What else can I help you with?
How do you add refridgerant to 1997 Geo Tracker?
How do you add refridgerant to a 1997 Geo Tracker?
Where is the fuel main relay switch on a 1997 geo tracker?
http://www.kick-fix.com/INJECTORS/depressure.html here
What kind of coolant does a 1997 geo tracker use?
The 1997 Geo Tracker uses Beck Arnley 252-1501C Blue 50/50 Premix coolant. The Geo Tracker has a coolant capacity of 5.5 quarts.
Where is the starter relay on a 1997 Geo Tracker?
How cha~ge oil tra~smisio~ of a geo tracker 95
Where is fuel pump on a 1997 Geo Tracker?
its in the tank
How do you change a fuel filter on a 1993 Geo Tracker?
93 tracker
1997 top selling car model?
GEO Tracker
What rear end will fit 1997 geo tracker 2wd?
No
How do you get the interior lights and the lights in the dashboard of a 1994 Geo Tracker to work all of the fuses have been changed?
change the headlight switch !
Is there a block heater frost plug on a 1997 geo tracker If so where is it?
The 1997 Geo Tracker block heater does have a frost plug. The Frost plug will be a few inches below the block heater.
Will a hood from a 1996 Geo Tracker fit a 1997 Geo Tracker?
Yes, a hood from a 1996 Geo Tracker will fit a 1997 Geo Tracker. Both models share the same body design and dimensions, making many parts interchangeable, including the hood. However, it's always a good idea to check for any minor differences in mounting points or hardware.
How do you change the dimmer switch on a 1991 Geo Tracker?
To change the dimmer switch on a 1991 Geo Tracker, first disconnect the negative battery cable to ensure safety. Remove the screws securing the dashboard panel and gently pull it away to access the switch. Disconnect the wiring harness from the old dimmer switch, then remove it from its mounting. Install the new switch by reversing the steps, reconnect the wiring, reattach the dashboard panel, and reconnect the battery.
