0
each light has a little slot on each plastic cover where you could put a screwdriver along the side. put the screwdriver in it a pull down the plastic piece is only snapped in. once you pull it down the piece comes off exposing the bulb. than you just pull the bulb out and replace it. Hopefully that helped a little.
What else can I help you with?
How do you change the lower ball joints on an Envoy 2004?
How do you change the lower ball joints on an 2004 envoy
How do you change the dome light bulb in a 2002 Lexus RX 300?
how do i change front interior light for lexus rx 300 2004 model
How do you reset the service engine soon light on a 2004 gmc envoy?
To reset the service engine soon light on a 2004 GMC Envoy you can remove the ECU fuse. ECU stands for electronic control unit.
How do you change a backup light for a 2004 envoy?
To change the backup light on a 2004 GMC Envoy, first, open the rear hatch and locate the tail light assembly. Remove the screws or bolts securing the assembly and gently pull it out from the vehicle. Disconnect the wiring harness, then twist the bulb socket counterclockwise to remove it. Replace the old bulb with a new one, reassemble the socket, reconnect the wiring, and secure the tail light assembly back into place.
How do you change a headlight in a 2004 GMC envoy?
there are 2 tabs on the top of the housing, pull up on them to release the head light, pull the housing forward to remove.
How do you get the check engine light codes on a 2004 GMC envoy?
With an OBD2 scan tool.
Problems with your 2004 gm envoy the alarm is not activated?
my alarm does not work 2004 envoy
2004 gmc envoy with code po128?
2004 gmc envoy with code p0128
How do you remove fan shroud on 2004 gmc envoy?
How do you remove the fan shroud on a 2004 get envoy
How do you change motor mounts on 2004 gmc envoy?
Take your car to a GMC dealership and pay $850.
How do you replace wheel bearings on 2004 GMC envoy?
how to replace wheel bearings on 2004 GMC envoy?
Your 2004 gmc envoy system is too rich what does that mean?
It sounds like you need to change the 02 sensors.
