0
Remove the brake drum, then take a big hammer and drive the bad studs out.
Then put the new studs in the whole and put a few washers on stud and then screew a lug nut on new stud and tighten it up and it will pull the new stud right in the hole tight. Then unscreew nut and do the same thing to the rest of them. NEUTZ.
What else can I help you with?
What is the estimated average mpg on a Chevy half ton pickup 1979?
You will be fortunate to get 15 mpg.
How big of a cam can i run in a stock small block Chevy?
Around 450, to 460, lift, 250, to 260 degrees duration, 116, centerline. New answer: If you run anything bigger then a 400 Lift, Then you MUST change the rocker arms to a LONG SLOT rocker arm are you will CUT the rocker arm studs in half. Even with the 400 LIFT it will still try and probley pull the rocker arm studs out of the head if the studs are pressed in like MOST stock heads are.
How do you change rear wheel bearing on 94 half ton Chevy silverado?
Look it uo on youtube
How do you change a body on a 85 Chevy half ton pickup truck 4x4?
what is the body being changed too?
How long should it take to change the thermostat on a 2000 Chevy B lazer?
Less than a half hour.
What is the amount of oil for a 2001 Chevy s 10?
4 and a half qts of motor oil with filter change
What is the name of a half car half pick up that was popular in the 1960s to 1970s?
Chevy had the EL Camino Ford had the Ranchero
How much oil is in an 02 Chevy s10?
The engine holds 4 and one half qts. of motor oil with filter change.
1979 liberty half dollar?
A US half dollar with a date of 1979 is a Kennedy half dollar not a liberty half dollar. The coin has no silver and is only face value.
How much is a 1979 Jefferson half dollar worth?
A Jefferson half dollar would be a real find, because Jefferson is on the nickel and JFK is on the half dollar. Regardless, a 1979 nickel is worth 5¢ and a 1979 half is worth exactly 10 times as much.
When was Half the Way created?
Half the Way was created in 1979-01.
How do you change a shift knob on Chevy Trailblazer?
There is a torx screw on the same side as the button, unscrew it half way and lift up the shift with the boot.
