1. Pop the hood
2. Locate the ignition coils on top of the engine (valve covers) and follow the individual plug wires (4 on each side) to the spark plugs.
3. Pull the wires off the plugs and use a 3/8" drive ratchet with an extension if necessary in conjunction with the proper socket (usually a 5/8) to remove the plugs by spinning them counter clock wise.
4. Once you've removed the old pugs make sure the new plugs are properly gaped as per manufacture spec and re-install with anti-seize on the threads of the plug (it's best to hand tighten the plugs before using the ratchet as not to strip them). Make sure to get the plugs snug but don't over-tighten.
5. Re-install the spark plug wires by pushing them back onto the plugs. They should make a "click" sound as they snap into place.
6. Check your work, your done!
How do you change brakes on 2003 Silverado Pick Up?
Twist the plug wires left and right until you can pull them off of the spark plugs, Then take a 5/8 socket and remove the plug. Wires are HARD to get off of the plugs.
The cost of insurance for a Chevy Silverado pickup is not a set price. The cost is determined by the driver, the company, and the coverage needed.
where is my hood latch located on my 1999 Chevy silverado pickup
No you can't.
no
The first Silverado Chevy was released in 1998 and it was a light pickup truck model named GMT800 Silverado. Prior to this, the term "Silverado" was used by General Motors to refer to the trim for the Chevrolet C/K pickup trucks.
Yes.
The 1998 Chevy Silverado pickup truck shift solenoid can be found on the left-hand side of the engine. The shift solenoid will be near the center of the transmission.
Check all vacuum lines
how to repace the distributor on an 98 chevy silverado
how do you change the knock sensor in a 2003 Chevy silverado 5.3