To change the speed sensor on a Ford E350, first, locate the sensor, which is typically found on the transmission or rear axle. Disconnect the electrical connector and remove the retaining bolt or screws holding the sensor in place. Replace it with the new sensor, secure it with the bolt, and reconnect the electrical connector. Finally, test the vehicle to ensure the new sensor is functioning correctly.
On a ford e350, the bank two sensor two is on the drivers side. The sensor is the one behind the catalytic converter.
IT MAY BE LOCATED IN THE TAILSHAFT OF THE TRANS, OR IN THE REAR DIFFERENTIAL HOUSING TOP FRONT DRIVER'S SIDE
which year model, what transmission do you have, and which speed sensor are we talking about?
replace abs sensor on back axel.
Speed sensor on a 2001 ford expedition
if your talking about the vss or speed sensor it has to be done under vech after you remove cat.converters
speed sensor is usually on the top of the differential on a ford
98 Ford E350 The AIT sensor is just after the air filter housing. It has two wire going to it, one is gray and the other is gray with a red strip. The sensor can be remove easily as it is just snug press into the rubber air intake housing.Read more: Where_is_the_IAT_Intake_air_temperature_sensor_on_a_Ford_Econoline_E-350
i've had this prob it's n the tranny check a ford repair book
Speed sensor is on the rear differential.
98 Ford E350 The AIT sensor is just after the air filter housing. It has two wire going to it, one is gray and the other is gray with a red strip. The sensor can be remove easily as it is just snug press into the rubber air intake housing.Read more: Where_is_the_IAT_Intake_air_temperature_sensor_on_a_Ford_Econoline_E-350
where is the speed sensor on my 2000 ford expedition v8 5.4 motor