On lower part of heater box inside vehicle (passanger side). Remove screws and unhook harness. Pretty simple.
Where is the resistor on 2001 jeep wrangler
Blower motor resistors are generally found nearby the blower motor.
in your but
Pull out the lock on the blower motor resistor wire harness connector to unlock the connector latch . Depress the latch on the blower motor resistor wire harness connector and disconnect the connector from the resistor. Remove the two screws that secure the blower motor resistor block to the HVAC housing. Remove the resistor block from the HVAC housing............
The heater blower motor resistor should be above the vent, behind and just below the glove box. It should have a three prong connector.
Check the resistor pack on or near the fan , it may have melted and needs to be replaced.
The blower motor resistor is under the glove box. There's a plastic cover over it. You remove the cover and you'll see a connector that is plugged into the resistor. You can see pictures at www.timsjeepblog.com.
it is under the clove box behind the blower motor you will see it if you look its a black box
Probably the blower motor resistor, check blower motor at the same time
blower resistor especially if its chrysler/jeep or blower switch
Either your switch is messed up, or more likely the blower motor resistor is bad.
Check to see if you are gettin power tothe blower motor - if so motor is bad If not, perhaps resistor or switch is bad Or open wire to motor or resistor