Open trunk and pull carpeting back from the rear lights and you will see wing nuts, take the wing nuts off and pull the complete light assembly out to change the bulbs.
FRONT OR REAR ?
In an Oldsmobile Cutlass Ciera, the brake light switch is typically located above the brake pedal, mounted on the brake pedal assembly. It is activated when the pedal is pressed, completing the circuit for the brake lights. To access it, you may need to remove any covering or panel underneath the dashboard. Always consult the vehicle’s service manual for specific details related to your model year.
The master cylinder contains the reservoir for the brake fluid. This is where you would add it on an 1990 Cutlass Supreme.
The brake pads on an Olds Sierra are a wearable part. When replacing brakes it is better to change both fronts or both rears at the same time.
Pull the tires off and take the brake calipers off and the rotors will pull off.
brake light on when driving oldsmobile alero
under the steering column above the brake pedal
DOT-3
One of two things. Either the brake light switch behind the brake pedal. Or try wiggling or rotating your turn signal stalk in a circle motion. If the brake lights work when the turn signal stalk is wiggled then you need to replace the turn signal stalk.
Replacing the brake pads on your 1982 Oldsmobile Cutlass is quite easy. Remove the brake pad Springs and caliper. The brake pads will come off. Reverse the process to install the new brake pads
It's on top of the brake pedal under the dash.
The 1995 Oldsmobile Cutlass brake rotors will cost approximately $40 per wheel. The rotors can be as cheap as $25 at some discount auto-parts stores.