Jack car front up pull wheels remove caliper, brake pads, rotor loosen axle nut remove 3 bolts holding wheel bearing/hub use hammer/chisel or air chisel to pry out the old unit from the front (it won't fall right out once unbolted and needs to be worked out) clean the hole out with fine sandpaper to remove debris and any peaks or rims then lubricate the hole with something like wd-40 or lubricant. installation is the reverse
bearings
hahahahah :D xD just joke
If you are referring to the front bearings, you have to buy a complete hub assembly.
blown brake hose, front passenger side in 1997 chevy malibu?
sorry to have to tell you this but the bearings are part of the wheel hub and sealed within. you need to change the entire hub. $$$$$$$
2005 Chevy Malibu, shocks in rear, Struts in front.
no
There are many dissimilar vehicles vehicles out there called Chevrolet Malibu, and front/rear wheel bearings can be different. Is your Malibu FWD or RWD? If fwd: no. The wheel bearings are ball-in-cage type bearings that are an integral part of the hub-and-bearing assembly which must be replaced as a unit. If rwd: maybe. The front wheel bearings are taper bearings held in place by a nut with cotter pin. The rear rear wheel bearings (axle bearings) are in fact pressed into the axle tube.
My 1999 Chevy Malibu has a fuse box under the front hood,
Yup
Possibly front wheel bearings or the front brake caliper's or sticking on. My car is doin the same right now. I'm replacing the wheel bearings and front caliper's,pad's and rotor's.
Remove the positive battery cable from your 2000 Chevy Malibu battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.