0
What else can I help you with?
How do you replace the harmonic balancer on 2000 Infiniti I30?
how to replace harmonic balancer on a 2000 infiniti i30
How do you remove harmonic balancer on 2000 cougar?
use a harmonic puller
Where is the harmonic balancer on a 2000 Chevy Silverado?
The front bottom PULLEY on the engine is bolted to the blancer.
What way do you turn the harmonic balancer bolt on a 2000 dodge neon?
Clockwise to tighten, counter to loosen.
How do you remove a harmonic balancer on a 2000 impala 3.8?
Take the serpentine belt off and then take the crankshaft pulley off and you will need a puller to get the balancer off the crank.
Where is the Crankshaft sensor on a 2000 lesabre?
The 2000 Buick Regal 3.8L Crankshaft Position Sensor is located behind the harmonic balancer pulley.
Does a 2000 5.3 liter vortec have a keyway for the harmonic balancer or is it just pressed on and held by the new stretch bolt?
it has a key in it.
2000 Dodge Intrepid 2.7 liter is the harmonic balancer suppose to wobble back and forth towards the radiator?
yes when its broken!
Where is the crank position sensor located on 2000 Mitsubishi Galant?
Behind harmonic balancer and timing belt on the 2.4 3.6-4 hrs
Where is the crankshaft sensor on a 2000 Dodge Durango?
Most crankshaft sensors are located above the harmonic balancer next to the timing chain cover . Good Luck Workin Man's Auto Repair ,Akron OhioMost crank sensors are above the harmonic balancer (front) or left of bell housing on the engine block (rear)
What thread size is in a 2000 mercury villager's harmonic balancer?
The harmonic balancer on a 2000 Mercury Villager typically has a bolt thread size of 10mm x 1.5 for the center bolt. It's important to verify this with a service manual or a trusted parts supplier, as specifications can vary slightly based on specific model configurations or engine types. Always ensure to use the correct torque specifications when reinstalling.
Why a 2000 Nissan sentra starts to shake when is not moving?
There is a good possibility that the harmonic balancer is bad...if it is, it'll destroy the belts and possibly more on the front (right side ) of the engine.
